Cable chain for the heatbed of the Tevo Tornado, it might also work with the CR-10 but I did not test that.
I switched from my anet a8 to the tevo tornado and I missed the cable-chain for the bed. Especially because there is no strain-relief for this printer.
I used the frame-piece of "stevenfayers" and slightly modified it so you can equate the z-height of the bed and the mounting point.
I used the trusty old chain of "sukhoi27" and modified it slightly to fit the cables. Now you can just put in the cables and close the chain link off with a pin.
For the strain-relief and bed mount I used the design of "Pemic' and just pasted a chain link on it
- 3 zip ties for the strain-relief,
- 2x t-bolt nuts + 2 M4 bolts to connect to frame.
- 2x m3 bolts and nuts for the last chain
5x "chainlinks open 4x" (you need 18 chain links)
18x "cable holder pin"
18x "cable holder cap"
1x "edited frame mount"
1x "mount last chain"
1x "bed mount with strain-relief" or "Carriage mount with strain relief"
Visit our site if you want to modify/design something or to order 3D printer parts online;
(currently only possible in europe)
Watch it here:
I used 35% honeycomb infill, with 3 perimeters, 3 top solid layers and 3 bottom solid layers. Printed in PLA and everything fit nicely