The original was very cool but bigger than I wanted- actually HUGE (using more filament than I wanted - hey I'm cheap) so I put it on a "diet" by cutting out the middle and shrinking the spout end (obviously left the threads alone as they are right for a 2 liter bottle!
Rev2: Had to run the Tinkercad output through Nettfabb so it it would slice better. Fixed file is attached
This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/aWVomKfC6BE
Just print it with
- minimal infill (10% or .1)
- 2 perimeters ,
- no support needed.
If you work on the original file, please be sure to repair the Tinkercad output- e.g. go to netfabb.azurewebsites.net