Fake or dummy suppressor for airsoft or replica use. 6 chambers with 60 degree "baffles". Should print standing up with 1/2-28 threads at the top. No supports should be required. Design is sealed with no access to the inside. 7mm ID. Threads have been offset by 5 thousandths because thats typically what works with my prints. Yours results may vary. When I have time, I’ll upload the STEP file. So that you guys can adjust that on your own.
Print using No Supports, with the threaded end upward. A brim may be used to ensure adhesion and stability during the printing process.
40mm OD x 150mm long / 7mm ID
If youre not downloading all the files, be sure you are grabbing the most recent one.
10/15/18 : slightly improved version posted. Marginally enlarged initial blast chamber and strengthened blast baffle for improved replica authenticity. total length is now 150mm.
10/21/18 : Added version with "dater holes"(probably not the correct term) to disrupt airflow and prevent over pressure. STEP file for this version was also added.