If you download it, please give it a like, and if you print it I would LOVE to see pictures posted!
I made the satellite dish myself in tinkercad, and I remixed eternal3lade's "Star Wars Legion: Communication Tower" for the base.
I would recommend trying to print the dish facing up, instead of facing down like I did, and like the file is. Or maybe use NOT tree supports. The forward facing detail of the dish was just kinda lost and muddied up.
I also did no work to these. I printed them and stuck them together. They're not even glued. I "snapped" the dish center into place after rimming it (giggidy) with masking tape.
I did 15% infill on all of it. The base is heavy enough to not topple over, but it wouldn't be a bad idea to make it a liiiiittle heavier. Maybe go 25%.
I usually use a 2 line brim, but had to increase it for the dish center. First print attempt it snapped off starting the 2nd ring at 15mm. I have not printed the "v1" center, only the V2.
I used tree supports for the dish. In hindsight, I don't think tree supports were a bad idea, but doing it face down was. The detail is smaller on the front than the back.