Also inspired by the origin thing (https://www.thingiverse.com/thing:1978823) which is not available anymore but with the body of the remixed one.
The only modification is the reduced height of the wings (half of the origin height). You will need four wing parts. Two of each have to be glued together with OHP transparency film in the middle using non-blooming, long curing super glue. The film was coloured with a normal permanent marker before the wings have been glued.
As this whoop is heavier than the normal ones you need in most cases better motors, and if possible a HV lipo. In order to give the HV type a better fit I enlarged the battery bracket with some heat from a soldering iron.
The motors I used can be found at https://micro-motor-warehouse.com/collections/all-motors/products/cl-0615-19
As FC the thing got an older F3-Beecore without OSD, Inductrix as well as Eachine e010 should be possible also.
The wings will work without raft.
For the body I recommend to use a raft and drill the motor holes after printing through hole and raft like shown on the picture.
Use ABS to get more flexibility.