A stabilizer for the charger and Juul e-cig.
The Juul e-cig uses magnetism to attach to the charger. This works great when the device is vertical, but when the device is horizontal it is very unstable and can tip down and disconnect from the charger. This is especially the case if you charge your device in a car and need to charge the device in the horizontal position.
This little object slips over the charger and allows the Juul device to slide down on top of the charging mechanism, giving it stability. Even in a bumpy car, with this stabilizer the Juul device is braced enough to stay magnetically attached to the charger.
V2 - Rounded edges, more compact and more precise fitting*
V1 - Not a perfect design, there is quite a bit of wiggle room, but it works functionally
- Depending on your printer, the fitting of the charger may be a bit too tight to easily remove the charger. Please let me know in the comments if the fitting is too tight and I can modify the design to make it easier to remove the charger.
Since it has a 90 degree overhang, I suggest support everywhere over 40 degrees.