You asked for it, here are the parts required to convert a Beta 75x into the Miracle Whoop!
In addition to the printed parts, you will need a Caddx Turtle (you can use either the v1 or V2).
You also will need a 20x20 VTx. We used the FullSpeed 600mW adjustable VTx, but anything that mounts to 20x20 stack will be fine.
MAKE SURE YOU INSULATE THE BOTTOM OF THE VTX WITH TAPE OR KAPTON!
You can use 15-20% infill depending on the type of infill used. We prefer to use triangular for everything, but rectilinear is fine and you can probably lower the density to 15% without any issues.
Make sure the gaps between the infill lines is less than 5mm and it will be fine.
All LunchboxFPV parts are designed for the same infill settings.