This is a remix of two good Ultimate 64 power socket and power button shrouds. This version takes the best of both designs and merges them into one (hopefully) universal design. While I really liked both original designs, one version was created for the U64 v1.1 board which uses a smaller power/reset/menu button and required some degree of filing to get it to fit proper without it causing alignment problems with the screw holes, and the other design lacks any sort of shroud for the power/reset/menu button but was an easy "slip on/over" design that fit without causing any sort of resistance or adverse pressure against the motherboard. I designed this hybrid version with a roomy opening for the power/menu button that should accommodate v1.0/1.1/1.2 boards (hopefully future versions as well). It takes the easy slip-on design from one parent, and the power button shroud from the other.
30% (doesnt matter really)
I printed with supports just to make cleanup a bit easier as the black filament I am using is rather stringy and doesn't bridge well. Decide for yourself based on your printer and the filament you are using if you need supports or not.