So, I had a hard time removing and remounting my Magpul CTR stock on my M4 airsoft rifle. Therefore, I created this tiny helping tool to easily aid the removal and remounting of this awesome Magpul CTR stock. This is a rather small item, so if it's lost or break, just print another one - hey, it only takes 4 minutes.
When mounting the Magpul stock, simply press down on the locking pin inside the stock until the Magpul CTR stock remover fits as shown in the pictures. Now when pressing the release handle, the stock can be easily removed.
When removing the stock, simply slide the stock out to an unlocked position, fit the tiny helper tool and follow normal procedure.
Remember that this little tool holds back a rather powerful spring and therefore it can slip and fly off in a random direction. Watch your eyes and fingers. I claim no responsibility to any damage done :)
Just hit print with no supports - it'll take about 5 mins to print. Since I don't have my settings under total control, the Magpul CTR stock helper needed a bit of sanding in post-printing.