Simple mount for a Slice Engineering Hot end with a 5015 part cooling fan and an EZABLE mount.
11/23/18; Updated the cooling to concentrate on the part instead of being to close to the hotend. New part is; Mosquito mount CR10SFIXED COOLING AGAIN v1.stl
Please if you print this be aware the 5015 fan puts out a bunch more air than the stock fan, I have been running the fan at 25~35% (set in slicing software) for PLA and about 15% for Colorfab Ngen and most PETG's
Printed with supports on build plate only, I printed the prototypes on the CR-10s but had to resort to my Prusa MK3 when the CR-10s had a bad thermistor
Clean up supports, add a 16mm PTFE tube between Mosquite and Festo fitting, chamfer the inlet side to make loading filament easier
All designed in Fusion 360, took measurements off the stock carriage and used the same distances for the nozzle location and EZABLE probe.
A couple of quick videos of the Mosquito in action