Ender 3 mount for IKEA Jansjö / Jansjo (led lamp at 88 lumen)
Updated version, read update below
I wanted some good lightnig for my prints/camera, so I took my sons bedlamp, IKEA Jansjö and made this mount for my Ender 3 (will have to buy him a new one).
Sliced with Cura 3.5.1, printed it "laying flat" with supports and 100% infill for maximum strength (most likely overkill) and Draft (0.2) profile. The print came out fitting perfectly and I actually didn't need screws to anchor it down so consider them optional.
The lamp is fixed to the base using the screws that it came with.
Update: 2018-10-24: Version 2
Bought myself a new Jansjö (red follows my theme (black, white, silver, blue and red are availiable so pick whichever matches your theme)) so my son could have his black Jansjö back.
Took some time and redesigned the mount (simplified it a lot), this one I printed with 20% infill.
I have removed the need for screws (hence the tabs are gone which saves some filament and time)
The screws and washers that comes with the lamp keeps it firmly in the aluminium frame. See pictures for details.
Both designs are availiable with the new one being version 2.
If you print version 2, tighten the screws until you get a tight fit in the frame (might not be all the way in), Thanks Balleknack for the heads up in the comments.
Printed these (https://www.thingiverse.com/thing:2333023) to keep the cable nice and tidy