IF YOU DOWNLOADED BEFORE 2245 CST 10/27/2018 PLEASE UPDATE FROM CURRENT
- There was a problem with the Top.stl where the changes I made the the magnet recesses in the sketch did not get transferred over to that form, so there is an error that was corrected and uploaded at 10:45PM on 10/27/2018. I am sorry for any inconvenience this has caused.
Dimensions are 99mm x 164mm x 17/19mm
For when you need a few extra D6s or D8s and you want to carry around your pencil and mini with you where ever you go. This box will hold 10 dice, a mechanical pencil, and any medium sized miniature (The only miniatures that I can't fit in here are my bugbear minis).
The case is held together with 18 - 5mm x 1mm neodymium magnets, which can be easily bought from numerous places like amazon and ebay. They can easily be held in place with some super glue or E6000 glue. The recesses for the magnets are 5.3 mm in diameter and 1.15 mm deep.
I would recommend putting in some thin packing foam to help protect and miniatures stored in this case.
Note that the pictures provided are of the initial print and I have added a few more magnets to help the lid stay in place a little better since then. If you have any problems with the print, leave a comment and please share any makes.
- Edit: 11/11/2018 - Uploaded V2 of holder, improved the overhang and edge between the two halves, decreased the height of the bottom section, increased height of top section. I haven't printed this new version yet, but as soon as I do, I'll post pictures.
- Edit: 11/26/2018 - Increased height of top and base, increased depth of miniature holding space to accommodate a 1" base (depth of mini holding area when closed is 27mm)
With these settings, 1 case should use ~100g of filament.