I added the Snappy v3 leg attachment to the case for a RepRapDiscount Smart Controller LCD Display.
The Snappy v3 assembly instructions don't include LCD placement, but from what I can see, this replaces one of the "Support Legs" on the Z-Axis, near the RAMPS 1.4 box on the left side. This makes all the controller and wiring have a smaller footprint.
I also added a "Big Wire Hole version" so if you have the same positioning of the wires on the back you can print that version instead. (I dremeled mine before I made it so I could fit the wires first).
Also, in the picture I am using the extra large reset button from this:
And I'm still nearly flush with the front because my board is so low.
Use the same settings as the rest of the Snappy v3 parts (especially as this is part of the support structure now):
Recommended slicer settings:
2 perimeters layers
3 top and bottom layers
0.25 or smaller layer height
20% or better infill (50% for drive gears)
No support necessary
No Raft or brim necessary