CHANGE NOTE 03/15/19 - KD_mono is more prettier and stuff
CHANGE NOTE 01/03/19 - Slight changes to kd_mono for elastic cord clearance when installed on an Esper.
CHANGE NOTE 12/06/18 - Being very unhappy with the single-piece design I've replaced it with a version that will be much easier to print. Will still require a separate trigger guard print though. Also now clears 25 and 30 darts drum mags.
Compatible with both styles of grip assemblies and all three ammo types. Can be pinned to the existings trigger guard, or attached to the magwell lower with the mag release pin-retaining screws.
"Right" and "Left" both need to be printed with buildplate supports.
Middle, Right, and Left attach to each other if you want the two-tone look.
"Tguard" can be printed and installed in the grip if you want another attachment point for the handguard. But you will need to remove the Tguard piece already installed in the grip and that can be difficult to do so it's optional.
"Tguard6" is only used with the 3-part grip assembly (namely the Ayy LMAO grip).
"kd_mono" is an easier-to-print single-part version that combines the Middle, Left, and Right pieces into a single upright print that doesn't need supports.