A simple pumpkin base for a jack-o-lantern for all your last minute Halloween or fall needs...
For whatever reason, it was really hard for me to find a 3D model of an "uncarved" pumpkin to make a jack-o-lantern. (The only one I found was an unsupported 123D file I couldn't use in Fusion 360.) For the custom logo svg I wanted to use, I couldn't extrude-cut with Tinkercad or use stamps in Meshmixer. In hindsight, perhaps it was just my file :)
Included the .f3d file for all the Fusion 360-ers out there, hope it saves you some trouble if you work in there directly.
The model was created in Sculpt mode, and is 4mm thick and hollowed out on the inside. Extrude your design, resize as needed, and use another extrude-cut to create an opening for the lid!
0.2mm-0.38mm Layer Height
(Depending on where you slice to create your lid, you might not need supports)