Loading
Elproducts

CHEP Calibration Cube

by Elproducts Nov 1, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

What infill % should I use for a 20mm cube, a 40mm cube, a 60mm cube, etc ??? thankk you

10% or higher should be fine.

Thank you CHEP.

I’m using “CURA” Slicer, should I have “Ironing Enabled” or “Disable” it? Or does it matter?
Thank you.

Don't enable unless you want the top to be smooth.

Thank you CHEP, I will print one this afternoon w/o ironing.

P.S. I've just subscribed and been checking out some of your videos on youtube. Very helpful and a wealth of information there. 8-)

Who printed the biggest CHEP cube so far ?

As far as I know, I did at 160 mm cubed

Comments deleted.

Just wondering... why exactly is this NSFW? :)

This model is looking one hella sexy UwU

What can I adjust if mine is not perfect? Do you have a filament Friday video on using it?

You have to recalculate your steps based off the measurements of your printed cube and then upgrade your firmware or settings

20 mm*CurrentStepsPerMMValue)/(MeasuredSide

Current steps 77.67
Measured side 19.85

New steps = (20*77.67)/19.85 = 78.26

Hey.
This is my first printout from Anet E12.
She came out perfectly!!! 20x20x20,05 mm. Awesome!
Thank you for the idea and your work.

Greetings and I wish you further ideas.
Agnus04