This is an unframed and reduced size and quality version. Thingiverse does not allow the full 450MB binary stl upload.
The full sized, full resolution lithophane(framed and unframed) is available on my site for those that want it:
This was a tough one to get right. I wanted the hot look on the top corners for the wizard lightning and sword, but wanted a colder colour for the centre middle and bottom areas.
I ended up using off white plastic to allow the hot look and splitting/blocking the backlight so warm white hit the top corners most and a second cold white light hitting the centre/bottom areas more than the corners. It didn't work out perfectly, but without going to extremes the colour/light blend is ok and I'm reasonably happy with it.
Photoshop CC 2018, PhotoToMesh V7, Meshmixer, S3D.
If you want the "Blaze" hot look you need to print in an off white material and then backlight it with a warm white led and cool white led for extra contrast.
Please note, it's easiest to slice this in Cura(or Slic3r and some other slicers). There are a couple of extra steps in S3D because of the way I designed this STL and frame. A bonus of this is there are some extra editing options available to you if you know what you are doing in S3D(connected meshes, cropping etc).
Check out more on my site: https://www.gadunky.com/