NOTE: Please acknowledge the License section. If you are looking for customized trophies or want to use these models for commercial purposes, please contact me! :)
This is a trophy collection for Minecraft gameplay tournaments of all kinds. 1st, 2nd, 3rd, and blank stands are all included. The sword press-fits into the small hole in the stand. I printed "diamond" for 1st, "gold" for 2nd, and "stone" for 3rd. You could easily mix and match diamond (light blue), gold (gold/yellow), iron (silver), gray (stone) and wood for your own rankings! For extra flare, you can print this model in Polyalchemy's Elixir PLA.
If you make this, please post a make of this thing. I may include your photos!
The font "Minecrafter" used on the trophy is credited to PurePixel/MadPixel.
I personally like the model sizes at 50% scale overall so that the prints were more manageable. Supports are needed for the peg on the sword, but no supports are needed in the stand.
The small peg on the sword should fit into the small hole in the stand. If it does not fit, lightly sanding the peg will allow it to fit. If it still does not fit, you may need to scale the sword model down a tiny bit and/or scale up the stand model a tiny bit and print it again.