This is a working WW2 German searchlight designed to be compatible with Playmobil figures.
This is the list of parts I used:
1: 3D print the parts
2: Sand the parts
3: Cover parts with model filler
4: Sand the parts
5: Spray with filler primer
6: Sand the parts.
7: Paint all the parts dark grey.(use a beige color for the control panel of the generator and paint the buttons with colorful paints.)
8: Follow picture guide below.
All the parts for the searchlight(except the led)
Parts for the generator.(except for the batteries)
Put aluminium foil inside the searchlight to make it shiny or just paint it with silver paint.
Glue these parts together.
sorry, bad photo! :)
glue the bearing in the lower casing of the base.
glue the top on so that it still rotates freely.(only put glue on the edges of the bearing.)
add the led
put the front of the searchlight on.
glue the seat to the base.
connect these two parts with the two bolts. Then glue it to the base.
Glue the top and middle parts of the generator together.
Press bottom into place.
Glue the hood onto the top of the control panel.
solder the led to some wire and thread it through the hole on the right side of the generator.
Wire it to the switch and the batteries and push the switch into place. You are done!