Medieval house

by 3Dlayeredscenery Nov 8, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Just finished printing this, came out great.
I recommend printing the 2 part roof though. I did the 1 piece roof and it took forever and used a crap load of filament for supports.

Hey I am glad to hear that, however I was wondering what settings you use? I design the roofs in a minimum angle of 45 degrees and most commonly around 55degrees so they should not need any support if your angle is set at 45degrees or more.

I had mine set to 30 degrees for something I printed the other day, didn't even think to reset it.
Also printed at 900% for 28mm gaming, and had it sitting up right.

It's all good though, I will post a pic when I am done painting it.

Ah I see that explains haha, Cool, I will look forward to your model!

Does it need supports? I'm in doubght about the windows frames.

Hey Jorge,

It does need a bit of support regarding the window frames, also for some reason (I use Cura) my slicer makes support for the roof however this shouldnt be possible but it still generates some of it underneath I tend to put the support overhang on the roof at 70% and on the floor itself at 55%.

No problem, Id love to see your make :)