This is a turn table for 3D scanning.
In particular, I have designed the turntable to adjust the distance and angle of the camera to reduce inconvenience of having to change the camera position when scanning small and large products.
To save cost of production and material, I minimized size of turntable and used parts that were readily available around us.
Selfie stick makes adjust distance from camera and goods and used ballpoint makes smooth rotating of the gear shaft. In order to check the angle of rotation, stopping holes are at every 20 degrees on back of top plate. The stopper spring is used in the ballpoint pen.
The use of selfie stick enabled any type of cell phone to be used to take pictures. turntable body allows to be fastened on the table or desk to withstand heavy cameras or cell phones.
I forget something a part. I used small thrust bearing in the top plate to reduce friction.
If you can't get it just use thin plate (washer : include stl file)
And I recommend wall thickness 1.2~2mm for clamping parts.
Feel free to support me on Paypal or at the Tip Designer button if you like this. It makes me design more creative goods. Thanks.
china PLA, ABS
Use PLA to Gear parts,
clamping parts and base plate must be used ABS.
And be sure of the direction of layers. It's Very Imfortant that the direction of layer
MUST Same direction with forced direction.
In case of 'stick holder upper' should be printed vertically.
And 'hook' should be rotated 90 degree against the picture. I mean the type of 'C' at the hook
is located upside direction.