Ideal for people who doesn't like / know electronic
Materials : Auto Off timer & photo relay, water pump, wago clip, dupont cable, 9-12V supply.
With this application you can Watering you garden once or Twice a day during few second or lots of minutes
i use a photo relay instead of daily timer because it's easy to work with. Especially when you reinstalled the system from one year to the next. ( nothing is needed ! ...)
Be sure not to run out of water :-) !
Ideal solution for your holidays
All design feat 8mm & 9mm inside diameter pipe ( min 8.75 - max 9.95 ) you can heat a little the pipe for easy installation.
You should have about
- 15-30 Holes for 240L/h pump
- 20-50 Holes for 300L/h pump
- 25-70 Holes for 400L/h pump
Printer Nozzle Width 0.4mm
I use transparent pla for house because their are a photo sensor inside house
-> i design the model for 6 shells and progressive infill 60%
-> i recommend 12-15 line brim
-> don't put the house directly under sun
Don't put support for bridge, it should output very well without any help.
I recommend white pla for Connector and ceramic carrot ( prevent sun damages as possible don't print it black ! ).
-> use 3shell and 15%infill
-> i recommend brim 5-8 line brim
EndConnector - ThroughConnector
Use a 3D pen to extend the grip, finish small pieces of filaments or ends spool filaments.
You can use 0.8mm / 1mm drill to clean hole if needed ( print setting is 1.2 - printerNozzleWidth = ~ 0.8mm)
You can clean the main hole with knife, but it should work anyway, I recommend not clean the small hole.
Use silicone to seal the carrot, Teflon Tape should work too.
Use a Knife to clean the hidden hole Photo Captor and Holes for electronic screw
-> I have hidden the hole for better first layer when bridge start. And it work very well !