Loading
Foba

Star wars: Legion AAT

by Foba Nov 13, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Awesome model. However when I create the gcode in Cura for example the bottom main section of the tank doesnt print. The front "headlight holes" are the only bits that hold the bottom of the base to the top of the base. Any thoughts on why this may be the case? An opening in the model somewhere perhaps.

hello!

Rotating it 75 degrees backwards (nose up) should fix the issue.

I'm guessing there's something inherently flawed with it, guessing that the outer layers are too thin for cura to register correctly when slicing it laying flat :/

hello!

Rotating it 75 degrees backwards (nose up) should fix the issue.

I'm guessing there's something inherently flawed with it, guessing that the outer layers are too thin for cura to register correctly when slicing it laying flat :/

Thanks for the quick reply! :)

You are right, it does actually fix the front nose from missing, however then the headlight holes are actually filled in. The cockpit also half dissappears at this angle also. :P

Hanve printed anyway with the bottom cut off which worked well jsut need to figure out how to best do the base.

The print is for terrain anyway (expoded version of the AAT) so can be a little bit missing. hehe.