Loading
SvenEDT

Atlas Titan

by SvenEDT May 5, 2014
Download All Files

Thing Apps Enabled

Please Login to Comment

Can someone remix this so it's holding the x0-16 chaingun?

I spent about 37 hours printing this in one big go, since I had the bed size for it. I'd never printed something using meshmixer supports before but I can not recommend it.

This might be my personal issue but I'll describe it anyway.

I sliced the model with Simplify3d and it was cutting out big chunks of the supports, so it wouldn't print properly. So then I put it through 3D Builder and repaired the model. When I sliced it again, all the supports looked good.

Unfortunately, the supports seem to be too incorporated into the model. They're going up under all the armor plates, and I was unabled to remove the supports without pieces of the model snapping off with it.

Just my two cents. I would love to find this same model with no supports included.

Is there a cretin filament that i need to be using when i make this

Pla would be easiest

so are the meshmixer supports apart of the file or should I use exterior support.

Have you done many prints with the meshmixer supports? I haven't found too many reviews. It looks interesting and I"ve been wondering how it stacks up against the standard supports in other slicing programs.

The Meshmixer supports print much faster and are easier to remove while using less material than tradition support. In the new files I uploaded, there is less meshmixer support, as the supports can leave a barnacle like texture on the model.