This is a remix to fit the cutting area of my K40 chinese laser, I first arranged the tiles as 3 sheets of 7 by 4 tiles, then realized my plywood sheets were a bit shorter than the actual width of the laser and rearranged the tiles as 3 sheets of 6 by 4 tiles and a sheet of 3 by 4 tiles for the river expansion.
I altered the river tiles into the river2 set in case I (or someone else) ever draws the corresponding expansions.
I also turned the buildings roofs into a darker shade of gray than the meadows.
I use the K40whisperer software with the halftone option set.
I raster engraved the grayscales at 300mm/s 35% of the laser power it takes about an hour(I did the first sheet at 100mm/s 20%, the finish is a bit better but it's slooooow, probably more than 3 hours)
The blue lines are vector engraved at 25mm/s 18%
And finally the red lines are vector cut at 10mm/s 35% (the wood is meranti 3-ply about 2.7mm plywood)
Update: I added a garden on 9 of the tiles for the abbot extension.
Update2: Added the "Inns and Cathedrals" extension, a set of eighteen new tiles. Added 2 gardens on these to keep the gardens per tile ratio.
Also added my set of meeples with a big follower and the abbot.
Coming up: Traders and Builders extension.