Bottom: No support
Top: Print upside down with logo on the print surface, with supports. Set "Support Top Distance" to "0.2". This will help with getting the support out of the logo.
Print speed: 40
Infill Density: 20
Layer Height: 0.15
Build Plate Temperature Initial Layer: 80c
Build Plate Temperature: 70c
I decreased the build plate temp after the first layer to reduce mushrooming.
The magnets I used 6 x 3 MM (I purchased these at Amazon https://tinyurl.com/ya24fuwu)
Post your prints, please.
March 6th 2019
Uploaded a new print with two normal size D6 on both sides.
Bottom is the same with numbers under the die (dicebox_figurine_bottom_two_d6.stl)
Two choices for the top, one with out the D&D logo (dicebox_figurine_top_two_d6.stl)
and one with the D&D logo (dicebox_figurine_top_two_d6_dd_print.stl)
Jan. 17th 2019
Issue: Top half of dice box missing the areas for the D6 and mini D6.
Resolution: Re-uploaded the top half of the dice box, both with logo and without logo.