Print in the orientations given
After printing, disassemble the tea light. Start by carefully removing the bottom piece of the tealight, it was easiest after removing the battery. Push the tea light base into the column base making sure it is properly aligned. There is an alignment notch and two pins that should all line up. The tea light should click into place and the LED will be left protruding from the top of the base.
Cut the acrylic rod to length, slightly less than 2". Test fit in column. The bottom of the rod should just touch the LED when assembled. You will also notice that the rod sticks out at the wrong angle from the torch. After removing the rod, bend the end of the rod using a heat gun to warm it up until it will stick straight out of the torch. After it has cooled sand bent end to disperse light. Insert the rod back into the column and put the plastic torch piece in place. Twist it while pushing down to insert the lower lip into the torch mouth.
Use the switch to turn on the light and you should be good to go, enjoy!
All the pieces need to assembly the torch
Notice the alignment notch in the upper left hand edge of the tealight and column base.
1/8" diameter acrylic rod, torch end bent (with heat gun) and sanded. A little less than 2" long.
Tea Light Image
If you like what I'm doing or use this in your game consider buying me a coffee or sending me a tip: