This is an enclosure for the Duet 2 Maestro for the (anet) AM8 frame. It mounts to a 2040 extrusion so should be compatible for plenty of other printers.
The Duet mounting dimensions were used to create this https://duet3d.dozuki.com/Wiki/Mounting_and_cooling_the_Duet_2_Maestro
Designed in Fusion 360.
There are plenty of extra holes in the case to get cables in from different directions.
I would love to hear any feedback for any of these that get printed.
Known issues ( I do not plan on reprinting this so am unlikely to fix these minor issues)
- On the side where the usb,sd card and Lan are, the board is not too close to the case side so getting the sd card out will be a bit awkward, this doesn't bother me as I will not be taking it out.
- Two of the mounting screws are underneath the supports for the lid. This makes it awkward to get the screws in and tightened but once again can still be done so didn't bother me much