The Name is Program
My Challange is to make a Plotter 4 under 120 Bugs.
This Think need so good like no Screws its designed 4 a lot of Zipties ;-)
U can build it in 2-4h
Low material cost
printed Parts @ Minimum
Some parts are not my design
Aluminium no cuts!
u need 4 suqare pipes 20x20x1000
some couples for the pipes like on the picture
4 rods D=10 x1000
a round pipe D=8x1000
2 stepper NEMA 17 (standart printer Motor)
a controller i use Makeblock better is a adruino GBRL solution
2 timing pulleys
3Gt timing belts min2000mm
a servo 4 Pen Plotter
a Laserhead for Lasecutting or engraving
printed linear bearings
and you need this beatifull design from Goeff! Big Respect to this Man! https://www.thingiverse.com/thing:2345588
More Infos later...
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.