Cleaning up the place in preparation for family and I decided my time would be best spent designing a tool holder for my Prusa. Then I would post the tool holder to Thingiverse and it would be five or six in the afternoon and... crud.
At any rate, many thanks to TheClarkJB for his original design. I have bent it to the will of the great and spiraled gods and I think they were pleased.. it's so often hard to tell with them.
It has space for two pliers (think the Prusa supplied needle noses for size comparison) and six holes for allen wrenches and screw drivers. It fits right above the power supply and keeps your work space clean and free of clutter. One square meter down, and only 185 left to go, and it only took two hours!.. carry the one.. crud.
The print takes about 45 minutes.
Update 20181230: I added a version with a 55.35mm clamp width for the Prusa Mk2.
Update 20190331: Scheindp20 troubleshot the print. V3 should be much more straightforward and all the walls weld together as intended during printing.
My treatise on spiral vase printing
V2 Updated for faster printing with a simplified design
V3 Models updated for more straightforward printing
Spiralize Outer Contour: