Housing I created for my IoT devices (all of them are based on great mysensors.org project).
Choose your size: S, M, L and print three models:
- side (two variants available here: 20mm height, 31mm height)
When you have all three models ready, then glue the front to side (I used ordinary CA glue), pack your IoT device and screw a back.
In order to get a super look, use a spray putty and paint it with spray paint, like I did.
Newbie PCB powered by two AA batteries with DTH11 sensor enclosed in housing L with 31mm side.
Inside housing you can find a wall separating electronics and batteries from sensor. The idea was to insulate electronics from unfriendly conditions in case device is used outdoor.