i made this one for an action cam to use it under water.
The handle is hollow respectively filled with 10% to swim up if lost in water.
There are two different mount plates depending on the cam you use or the case you use for the cam (underwater or on land).
I used a 12 mm alu pipe, a m5 nut (mount plate) and 2 m3 nut and bold (handle).
Handle printed with 10% filling.
plates and screw in 100%.
Used in summer at spain and it worked perfectly :-)
For questions leave a comment.
If u like it, like it!
Tianse 1.75 PLA