Prusa MK3 Enclosure Bracket for LCD Controller

by sneaks Nov 24, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

so handy in this way. The cables of the CPU are just too short to pass through the opening of the table leg. this is a good solution thumbs up

Hello. Good thing but a problem about dove with first layers in 3 parts at differents heights : it give bad result during printing. You can fix it please ? Thank

I don't understand. Perhaps you can post some pictures?

The first layer is not at the all length. The first at 1/3, the second at 2/3 and the third at all length. This give like a warping, bad adhesion on the bed.
Perhaps it need to print vertically ?

Hi Claire, this isn't an issue with the part, I suspect it is an issue with your slicing software not laying the part flat on the print bed.

What slicing software are you using? You need to make sure the bottom of the part is perfectly parallel to the print bed. If it is off even slightly, you'll have these issues.

I use Slic3r PE and i solve the problem with the option (at the left the last of the three icones) to choose the face placing on the "bed" of the slicing. Ok with my last print but. Bizarre :)

Awesome. Glad you have it working ;)