Frame: 2020 aluminum profile (20x20 and 20x40, European Standard, V-Slot)
Controller: DuetWifi + Duex5 (www.duet3d.com)
Hot End: Kraken (4-nozzle, liquid-cooled)
Linear Rails: MGN12 rails with MGN12H bearing blocks
Stepper Motors: 42BYGH (4 lead Nema17)
Lead Screws: T8
Bed Connection: KD516 magnetic ball joint (permits independent movement of the three Z motors without binding)
Build Volume (x,y,z): 330mm x 376mm x 335mm (13" x 14.8" x 13.19")
Outside Dimensions (x,y,z): 559mm x 559mm x 711mm (22" x 22" x 28")
there are two horizontal holes. You can put two M3x45 screws/washers/bolts in these to reinforce the clamp.
To hold the belts, loop them in the holder and insert a M5 screw. Nut/Washer is not needed.
Rear bed bracket
Same as the other two brackets. Just attach the support plate with M3x30 screws, washers and nuts,
Enclosure: If you glue a piece of fiber optic or translucent filament in each of the four small holes (of the cover) it will be easier to see the status LEDs.
Controller: JohnSL (https://github.com/JohnSL/FSR_Endstop)
FSR support: Printed supports with 1/4" neoprene sponge between FSR and build plate.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.