LC meter case
by egil, published
Liked ByView All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
Improved version of the case for the the LC-100S inductance/capatitancy meter. This instrument is readily available at very low cost (approx USD 30) on ebay and elsewhere, but comes as a bare PCB without a case.
This new, improved version is based on the improvements made to my original version by linearchaos in http://www.thingiverse.com/thing:376273 . It is tuned even more, and also adds a real button for the "Func" key.
There is one variant for the 4-button and one for the 3-key version of this meter.
See build instructions for useful hints. (The picture shows the old version)
Note: If you consider buying this meter, you should also look at the meter in http://www.thingiverse.com/thing:641003 as an alternative. It can test quite a few more types of components.
Should print straight ahead in PLA without any additional support. The upper part has support tabs included around the LCD. These should be broken or cut off. The button may need some cleanup with a sharp knife.
Needs 8 countersunk 3 mm screws for mounting.
Further improvement of the design can be done in the attached SCAD file. The two modules are called "upper" and "lower".
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
LC meter case by egil is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving egil a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure egil would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).