Nintastic long version

by firebirdman May 8, 2014
Download All Files

Thing Apps Enabled

Please Login to Comment

Version without holes in the bottom of the case?

Sure, there you go.

Thanks a bunch!

Is there a slot for the ribbon cables? (GPIO & Camera)

I'm not sure I understand the question, but there is nothing blocking the pins inside the case, ie. both ports are usable. There are no holes to route the cables out of the case, though.

That's what I needed to know ... I'll keep looking for a case with holes for the cables. Thanks for the reply:-)

I can make a version with a couple of extra holes. What size and where would you like them?

I am just beginning to work with 2 old RPi B units. My grandson got a Monoprice Select Mini 3D Printer yesterday for his birthday. I googled it and found cases for the RPi. I don't know enough to tell you the size & location needed. I'll need to do further research to find out. Can I contct you gain in the future when I have learned more?
Thank you very much for your time, I appreciate it.

Does this link have the information you need?
Raspberry Pi 1 Model B.zip selection at :

Yes, if you want the holes for the cables directly above the ports. Which, incidentally, will put the ports on the bottom of the case, since the Pi is upside down in the case. But, if you measure the connectors that you need to thread through the holes, you can have correctly sized holes on any side of the case, whichever best suits your needs.

OK, Thanks for your time ... sorry if my questions are vague but I am just beginning to learn about the RPi and 3D printing.

Looks great! Would you mind posting the flap file without the logo please?

Here you go! My printer is out of commission at the moment, so this hasn't been printed yet. Let me know if it works for you.

Nice save on the SD card, I was skeptical on getting the original for that reason exactly, good job! :D