I created this for and wore it at my wedding. Its a create DIY accent to an outdoor wedding day look.
The completed headband is made up of 6 leaves printed separately and connected using small 4mm silver jump rings which can easily be ordered off of Amazon. As a bonus, these loops are great for sliding bobby pins through to secure it to your hairdo, although it stays in place surprisingly well on its own. The base of the headband then ties around your head using a thin ribbon.
It is created this by adding loops to the MakerBot Maple Leaf model, and then assembling it into the headband post printing.
Read the full story about how I 3D printed my wedding here: https://www.technologyreview.com/s/612486/i-3-d-printed-every-bit-of-my-weddingincluding-my-bouquet/
Photos by Mark Pariani