I designed this Advent calendar in the shape of the Deathly Hallows from Harry Potter. This was my first design project so hope you like.
I printed my one in PLA Wood on a Flash Forge Creator Pro.
Due to the size I had to make the sides in 6 pieces and glue together. I used Gorilla Glue as the surface wasn't flat enough to use Superglue.
I added the wand from "Sancharizard" just scaled down to 100mm long. This can be used to pull the drawers open if stuck.
I added a piece of white card to the back to stop the drawers pushing through.
The numbers were highlighted with a metallic pen.
I had trouble getting the PLA wood to stick to the bed so I ended up raising the temperatures from my normal PLA settings
Extruder - 210 degC
Bed - 55 degC
I chose to put supports on boxes 23 and 24 as I wasn't sure whether it would print the curved base otherwise.
Boxes were printed 6 at a time and took about 6 hours each set