Designed in Fusion 360,
The BEST Spinning top on Thingiverse.
Made for long spin time.
Body and tip are printed seperately.
Body should be 30% infill and Tip should be 80%
Both should be printed at a fine resoloution.
stem has a Hole through it for less upper mass, and the tip is solid @ 80% for great balance! Center beam across outer wing is to keep good momentum.
no suppoerts, no brim, Super glue Tip to the body the tip is 1mm smaller than body shaft. sand the tip lightly with 600 grit and then ru a lighter over it for 1 second to smooth the tip
Spinner Video from trevor foxall on Vimeo.