Orca 0.4x Hotend cooling ring

by Okatake Oct 17, 2012
Download All Files

Thing Apps Enabled

Please Login to Comment

Hi there, I'm using your settings, but slic3r seems to have problems creating the bottom part (around the nozzle) it's not there at all.

Any suggestions?

Hi paoel.

Please refer to the ini file I uploaded "Slic3r" was used to generate the G-Code.

I think if the support material is an issue that remains inside the nozzle, and may be removed by hand things remaining in the set to three degrees the angle of the "Support material Overhang threshole".

Please print it and modify it as needed is a reference value set.

Hi there, thanks for the quick reply. Unfortunately no luck. 

Slic3r is giving the error that the model contains intersecting facets.

See the print screen using your settings:


Hi paoel.

Appears normally tried by "Repetier-Host V0.74".I've tried the steps listed below.

1.(Repetier-Host):"Repetier-Host V0.74"→"Slicer"→"Slic3r(Configure)"2.(Slic3r):"File"→"Load Config"→[CoolingRing_v10_3.ini]2.(Slic3r):"Plater"→"Add"→[CoolingRing_v10_3.stl]3.(Slic3r):"Export G-code"→SAVE G-code→Close Slic3r4.(Repetier-Host):"File"→"Load G-code"→File name of the No.3

Thank you.

Success! Cheers!