new better version!!!!! (still in work)
i Just need a Circle jig for my small handrouter
so i redisign the baseplate ( orginal is black) to mount a 8mm threaded rod
I print it with 100% infill for maximum strongness
and just a small support at the ground
i cleaned the holes after the print with 4,5mm and 6mm drillbit and countersink all
i added a new version of this plate, because the first one wouldn't give the result i want to.
the new one is much better than the first but with the old one you can make it for your own
in the new version you can now set the circlepoint better and easier, you can use M6 Screws and wingnuts to tighten the slideing circlepoint.
you should drill all holes again appropriately, in the slidingbar with 5mm to get a shelf pin in there
you printer has to be calibrateted for perfection
Tianse PLA 1,75