Clip to hold index cards to your DM/GM screen for initiative in D&D and RPG games
Added a new clip with shorter "legs" to help reduce obstruction of the DM's screen's content.
Added (at user request) a clip to hang index cards instead of holding them above.
In the current version of Cura (3.6) it loads up in an orientation that requires no supports, and provides the most strength. When printing it should lie flat on its thinnest side.
Designed it to work with a .4mm nozzle and .2mm layer height . Took about 20 minutes to print using standard draft detail settings on my Ender 3.
Note: My slicer settings currently cause a small extrusion about midway between the index card clip sides. This is due to a small amount of stringing that occurs when it fills in internal space on the left then right side of the clip.
If this an issue for you, just sliding a razor or x-acto blade in there cleans it right up. Not much of a hassle.