Loading
Jimbotron

Bearing Captured in Möbius (Mobius) Cut

by Jimbotron Dec 12, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

would like to see a file with just the bearing to then drop into the print half-way through.

That should be pretty easy. I'll see what I can do. (10 minutes later) Done and thanks! that was a good idea.

Scale to 38% - 39% and insert "6mm" airsoft bearing(s). My very first try at 38% doesn't quite allow the bearings to travel freely and is too ugly to show as a Make, but there's definitely some promise to the idea, at least if you have some of the bearings on hand.

Thanks for information. I haven't tried scaling down this print yet - but with a ~6.4 gap i'm not sure if i'd be able to get a file or sandpaper in there to file it out. I may give the 6mm bearing size a try and see if I can get it working. Unfortunately, this design is very unforgiving for any hairs or zits in the print.