Several years ago, the front wall of a storage compartment at the refrigerator door (Zanussi) was broken.
Since then we have not been able to use this compartment.
Today I took care of this problem.
- approx. 30 minutes time (measure door/clamp and designing the 3D model)
- 40cm aluminium rod (2x15mm)
- approx. 25g plastic (incl. small pre-print to test if it fits)
- one hour printing time
... problem solved :-)
And because I was already fixing it anyway, I also adapted my design for the lower (already repaired) compartment.