Loading
3D-FloW

Ender 3 - Fresh Air System for Melzi Board v1.0

by 3D-FloW Dec 13, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

bonjour, sa ne refoule pas les particules et les odeurs ?

How much difference in internal temps within the mainboard case did you notice post upgrade ? are the fans operating ok with having to pull air through a flexible hose ?

My Enclosure is very airtight, so temps inside reach 30-50 degree, printing ABS. Inside the mainboard case i have now 25-30 degrees during printjob and i think thats really good temps. So yes it works, even through a flexible hose. (I have to say i dont use original mainboard fan, now im using a „40mm Noiseblocker XM2“ with 3800U/min, so idk about temps with original fan)

Thanks for the rapid reply, I'll have to give it a go, was planning on relocating the electronics but I think I'll just go this route. Thanks again !