This is a TriPod mount I designed for the Osmo Pocket.
It uses a 1/4"-20 "knurled insert" threaded brass insert so you can mount it to a tripod.
Which is glued in place with 5 minute epoxy after printing.
The design is offset, do that you can still have the USB cable plugged in while it is mounted.
I use it with a power bank that has a tripod thread at the top.
Be aware, that all printers are different, you may need to scale the design up or down 0.5% or so to get a nice snug fit.
No Support Needed. I did mine at 40% fill but that was probably over kill.
I have also included the Fusion 360 file if you would like to edit the design.
Please link and share your versions here.