Printed CR10s 200 nozzle degrees, 65 bed, .8mm nozzle, .3 layer height, 20% infill, tuned out great. The top of the hands have little holes. I used the masking tape to hold the support but it doesn't look like the support was used.
I made it 282mm tall, hole deeper 80mm and the pot taller/wider, 80x81mm. The original design I modified, https://www.thingiverse.com/thing:2961492
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.