This Beach Scene fridge magnet and ornament uses a 10mm x 3mm magnet that we purchased from Amazon in a pack of 100 for about $10. The magnet can be glued inside the hole in the back with super glue or Goop that we purchased at Home Depot. We also added 4 ornament hooks so you can hang on your Christmas tree or wall. We included medium and large sizes in 1) a blank design (no text), 2) 2018, 2019 and 2020 version with no text so you can add your own text, 3) "I Love You" text with 2018, 2019 and 2020 versions. (we are preparing for the future :)
You can add your own names or perhaps something like "The Smith Reunion - Hawaii 2019" or you can merely write something or 3d print something and glue it to the bottom section.
Enjoy and Merry Christmas from the IEC3dDesignWorks team.
Prints in about 1 hour at .20 resolution. Due to the large footprint, warping of the base can be an issue on printers without a heated bed. You can use a mix of your glue stick (we like elmers) with a bit of hairspray on top and mix them with your finger or a stiff brush until it is a white slurry and very tacky and no longer wet and slippery. We use this slurry on top of blue tape on many prints that have over 100 mm length or large rectangle base. The large print is 110 x 90 mm. Our printers with a heated bed usually only need the glue stick.
The bottom layer of blue filament is 2 mm thick and you can change to red filament when you see the letters start printing. The letters are 1.5 mm tall so when they are finished printing, change to brown for the umbrella which is about 3 mm tall, so you can change to brown within the last 10-20 minutes if you forget to watch for the letters to finish printing.
Merry Christmas & Happy printing.