The switches I used are "big" because I could not find any smaller nearby. The only micro switches I used are on the Z axis and they are bolted to the structure all the other parts are screwed to rails or fixed with double side tape.
Once you activate the end stops the Offline controller stops working, to make it work again you must use "$21=0". If you know a way to make it work with the end stops enabled, please let me know. ;-)
I've add 2 switched on the box cover. One for the box fan (It's a bit too loud) and another for the Spindle (safe precaution) Both were add with a soldering iron after the box was printed and that's why there are no holes on the part. :-)
The end stop switch holders for the X and Y axis are different there is a Front and a Back model (Y) as well a Left and a Right one (X). Don't print the same model twice!
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.