Everyone with a lathe or mill always hates the clean down afterwards, usually leaving a stack of dirt and chips around the machine.
Magentic Swarf Sweepers are nothing new, but this one is unique,
I have modelled (parametrically of course) printed parts, so all you need is some M5 nuts, M5 rod, a selection of Neodidlium magnets (20mm dia) and some copper pipe, and these files to make your very own swarf sweeper.
(or modify accordingly to your own junk on hand)
I polished up the Copper tube on the lathe, and cut to length, however this is not needed, just grab your vitamins, and adjust the parameters to suit your parts, and no lathe required to make your own, just basic hand tools, e.g. hacksaw to cut pipe and M5 rod to length